|Topic Review (Newest First)|
|01-29-2013 03:04 AM|
Originally Posted by wendyjo View Post
Bacteria live on the plants as well. I imagine you took good care of them in transit, therefor all your bacteria survived the trip on them. How about your filter did you possibly take good care of it too.
A cycled tank is a mature bio-filter. Since you carried your bio-filter with you and dropped it into the new tank, than it goes without say that your tank is cycled. But like John K said, be sure it can handle your intended bio load.
As far as rising nitrates, you basically stirred up a ton of ammonia when you stirred your substrate. Your good to go.
|01-26-2013 12:54 AM|
Thanks for the replies thus far!
-The tank has been set up for about two weeks now. Initially, ammonia, nitrites, and nitrates were zero. this week I started seeing 5-10ppm nitrates.
-I only have three small fish (a Malawi cichlid fry, a rummy nose tetra, and some odd yet unidentified small fish) and 5 onion snails. All were transported in a tupperware aquarium w/ battery air pump and small heater during the move.
-The substrate was frozen at some point during the move. It was kept submerged in air tight 5 gallon buckets for a total of 1 week. Long time, I know.
-Filtration is accomplished by a pair of Aquaclear 200's. All filter media was new when I set up the 75.
-I believe that the tank has been seeing a steady amount of ammonia due to a large amount of dead snails in the substrate, decaying plant matter, the fish being in the tank, and the huge accumulation of snail dung on the bottom of the tank. The snails have stripped a layer off of all of my drift wood.
I've been holding off on dosing ammonia since I have the three small fish in the tank currently. However, my fiance's 29 just finished its fishless cycle, so I can move the fish to her tank. If my plants weren't begging to be let out of the cooler and the fish weren't so cramped in their transport aquarium, I would have just cycled this tank with ammonia like I did my 55.
|01-25-2013 01:28 AM|
Assuming the substrate is moist, even a week in transit is nothing for the bacteria. Theoretically, it's no different than disassembling a tank, moving it across the room and reassembling it. Since nitrate is being produced, it sure seems like a cycle is happening. I would suspect that decaying plant matter, dead snails, etc could be the ammonia source.
But of course, it's important to make sure it can handle whatever the intended fish load is. Adding ammonia is a good way to do this.
|01-25-2013 12:20 AM|
Totally agree with 2Shi.... it ALWAYS takes a few days if not a week. Run the tests to see if it can handle a load of ammonia.
|01-25-2013 12:17 AM|
Some sources of tap water contains nitrates, so test your water straight out the tap and see if that could be what's going on.
Is your tank stocked at all?
|01-25-2013 12:09 AM|
There's no such thing as a tank that instantly cycles if you take a few days to move it long distance. While some beneficial bacteria still remains, there may not be enough to instantly support a full tank load like a properly cycled tank.
Your best bet is to dose ammonia and see how much the tank can actually handle. Some may be converted into nitrites while some may remain ammonia. Don't use nitrate levels as a sole indicator of a properly cycled tank.
|01-24-2013 11:20 PM|
|jonathan||How long has water been in the tank ?|
|01-24-2013 10:17 PM|
|John K||The bacteria live on surfaces, like the substrate and plants. So by using them in your new tank, it was instantly cycled.|
|01-24-2013 09:56 PM|
Tank self cycled?
I recently moved across the country, taking all of my old substrate and plants from my 55 with me. When I got here, I set up a 75 with the old plants and substrate. I never dosed ammonia (which is what I normally did to cycle the tank) and have never read ammonia or nitrites. However, I am reading a slowly rising level of nitrates. Is the only way to get nitrates through the nitrogen cycle?