|Topic Review (Newest First)|
|01-15-2013 03:42 AM|
My gut tells me I'll be fine with these lights to start. Realistically with a 2" sand bed, and the tank isnt full to the brim, I'm looking at just under 18" of water to penetrate through. looking at a chart needed for coral growth, mushrooms, zoo's and soft corals need 50-100 PAR (bottom of tank) LPS, clams and some SPS need 100-200 PAR (top of tank).
If I decide on going SPS, I'd need more lighting but also alot more other things would have to get upgraded or installed!
|01-14-2013 10:06 PM|
|jbrady33||thanks for the correction, grabbed the wrong image!|
|01-14-2013 09:58 PM|
Here's correct picture for DS Ray2.
|01-14-2013 09:03 PM|
Thats not for the DD or DB series. hopefully it doesnt matter much like you said. Just wanted to make sure before i buy
Tank is 48"h x 18"d x 20"h. Thinking about 6-12inches above is where I would hang it
|01-14-2013 09:01 PM|
The PAR data for all of the Ray2/FugeRay line is in a sticky at the top of this forum
here is the Ray2 in 48"
I don't think the color temp matters much. I would go with dual 6500k myself.
as for the spill over - how wide is the tank and how high are you suspending it?
|01-14-2013 08:07 PM|
PAR data for 48" DD and DB RAY2
Wondering if you have these available? any charts with 2 of each side-by-side? Looking for lighting for my SW tank. Tank is 20" high.
In your opinion, for a 48" tank, would a suspended 48" RAY2 have too much "spill over" past the tank? should I just get a 36"