The Planted Tank Forum - Reply to Topic
Planted Tank Forums
Your Tanks Image Hosting *Tank Tracker * Plant Profiles Fish Profiles Planted Tank Guide Photo Gallery Articles

Go Back   The Planted Tank Forum > Specific Aspects of a Planted Tank > Aquascaping > Clean bad BBA off driftwood?

Thread: Clean bad BBA off driftwood? Reply to Thread
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the The Planted Tank Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-05-2013 06:37 AM
Allentan97 just let the wood sit out for a an afternoon
will still stay water logged but outside will be dried, along with bba
01-02-2013 12:38 AM
malloy85 Anyone ever tried treating with boiling water to kill the bba?
12-25-2012 01:19 AM
Diana If you can remove the driftwood many things will work. Then a good rinse and return it to the tank. Any of the materials listed are safe to add to the tank in the small amount that would cling to the wood if it was not well rinsed.
12-24-2012 11:42 PM
KH2PO4 Rub it with dry or very concentrated solution of KH2PO4, leave it for 15 mins,
will turn red by the next day, got better result than standard 3% H2O2.
12-24-2012 05:02 PM
Diana If you cannot take out the driftwood:
Figure out how much Excel OR hydrogen peroxide is the maximum dose for your size tank.
Turn off filters, power heads and any other water moving equipment.
Use a syringe without the needle and squirt that much Excel OR hydrogen peroxide right into the densest parts of the BBA. If there is still a lot of BBA you might not get it all treated in one go.
Let it sit for a while, then turn the filters etc. back on.
The next day do a partial water change (25% minimum) and repeat. If you were not able to treat all the algae the first day, you could treat the remainder today.

When it turns pink, it is dead. Sometimes it takes 2 treatments like this to kill it. Sometimes it dies with just one treatment.

If you have so much BBA that it will take more daily treatments, then I would do larger water changes, practically drain the tank, then squirt or spray the Excel or H2O2 directly on the exposed BBA. The stronger concentration of either of these materials when the algae is in the air can kill it better that gambling that the water is still enough to maintain the concentration when you treat a full tank. When you do it this way (drain the tank, treat exposed algae) you can use about double the amount of H2O2. Then wait until the bubbling quits before refilling. Most of the H2O2 will have changed to water and oxygen so is not toxic.
12-24-2012 03:56 PM
fenderfreek I've got a little that lives on despite CO2. The best thing I've found is running a high dose of Excel in it for a while, that tends to keep the stuff knocked down.
12-24-2012 03:02 PM
HybridHerp Will BBA die off on its own with addition of co2?
I had most of my BBA die off after a 2 wee power outage, but I'm not sure how to get ride of the last few bits of it. It's also on pieces of wood that I really cannot take out of the tank anymore without disturbing everything.
12-24-2012 07:10 AM
Kathyy If you can remove the wood then scrape the BBA off with a dull knife and rinse the wood. It probably would be a good idea to try to kill any remaining BBA with H2O2 while it is out of the tank. You want to get its 'roots' off as well as the brush part. Even if you do stay on top of things and BBA doesn't return those little bumps aren't very nice looking.
12-24-2012 04:19 AM
penpal You can just run hot water over it. Itll turn red and die off after a few days
12-24-2012 03:25 AM
etgregoire If u can pull it out u can spray with h2o2. You can also use excel. You could also do a bleach dip which I think is a 1:20 dilution with water and then cleaning with water overdosed with dechlor. Look on the forum as there is more in depth descriptions. Personally I would pull it out if possible and scrub with a toothbrush and dip it in h2o2.

If u can't remove it you can spot treat with excel or h2o2 using a syringe. Look up the safe dosing amounts of h2o2 if doing directly to the tank.
12-24-2012 03:02 AM
dannahlea2001
Clean bad BBA off driftwood?

I let my aquarium go and it's overun with BBA. Is my driftwood salvageable? If so, how to I clean it? This beard algae seems to be permanently stuck.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT. The time now is 10:51 AM.


Powered by vBulletin®
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Copyright Planted Tank LLC 2012