|01-03-2013 04:29 AM|
I baught myself seachem equilbrium...
Exactly what do you dose in your tank?
Thats more then enough for my plants
|12-27-2012 05:46 AM|
|12-27-2012 02:32 AM|
Get yourself some Seachem Equilibrium and you'll be all set. Here is a pic I just took for you....
|12-24-2012 03:35 PM|
|chad320||Epsom Salt is MgSo4. You can get it at any Walmart or Pharmacy.|
|12-24-2012 03:09 PM|
Plant, your right. It is magnesium deficiency!
Where exactly can i find some MgS04
Seachem discuss buffer? Replenish? Or equilbrium?
|12-21-2012 04:32 AM|
It's one of two things: veining of leaves, common in Swords and in Anumbias, but few other species.
The other is a general color loss of greens and slower limited rate of growth.
Adding MgSO4 back will restore the green color very fast(it's the central atom in Chl a, b etc, other wise the molecule is grey in color). and should restore the veining issue in a few days.
I've had everything from 0.3 ppm in tap up to about 50ppm of Mg. In dense tanks where folks do not add any known source of Mg, it can and does happen, most often when folks assume their GH is a nice balanced ratio of Mg and Ca, sometimes it is all Ca++, but extremely rarely, it might be mostly Mg, I've never seen a tap like that yet but perhaps one does exists somewhere. GH measures both Ca and Mg, not both.
If you dose a known source of GH, say GH booster, which is about a 1:4 Mg/Ca, then you know you will not be limiting.
Or most add MgSO4 to their CMS mix for traces.
|12-20-2012 11:42 PM|
My plants grew fine in higher kH and gH than yours. Some of them like Vallisneria use kH as a source of Carbon and some do not like it at all as it will limit CO2. Tonina on the other hand prefers soft water with lots of CO2.
There's no short answer to all plants. You will need at some point to experiment and learn which are the values that yield the expected results.
|12-20-2012 10:55 PM|
|chad320||I would add MgSo4 anyway. It cant really hurt. I belive the PPS-Pro home page has measurements for it.|
|12-20-2012 10:47 PM|
lol ur plants should grow fine the way ur parameters are for kh and gh
|12-20-2012 09:32 PM|
|SpecialEffect||So to lower kh... Peat or black water extract? I dont want to lower my ph though|
|12-20-2012 01:13 PM|
some sensitive species will do better with lower KH.. but they will grow just fine in higher KH, just likely not to grow as fast, or as colorful
again ur plants should grow JUST FINE
|12-20-2012 09:26 AM|
|danielt||kH higher than 4-5 is "high" for a planted tank in my opinion. Peat or blackwater extract will lower your kH and the pH as well since there will be less acid buffering.|
|12-19-2012 11:32 PM|
Well... Got my kh/gh kits... Tested my water...
Aquarium (based on mid-day of co2)
Nitrate: 8...between 5 and 10
How's the tests?
|12-19-2012 05:39 PM|
|danielt||Get a hold of your kH value. If the kH is high you don't have actual CO2 in your water. You will need to lower kH to have more CO2 available to your plants. You either lower kH or increase CO2 input.|
|12-19-2012 04:51 PM|
Nah, they look fine... My 3 flying foxes swim around eatting... My 9" red belly stays in his corner and just chills like usual. With his random bursts of energy whn someone walks by begging for food.
While i wait for my gh/kh test kit i also ordered a fluval Q2 to oxygenate the water while lights are at 1% moon light... Probably going to have it run untill my "sun rise"
And for my lighting... Idk... EVERYTHING has exploaded in color and growth ever since i got these lights... 4 years an never seen such color and growth... Pearling to a hole new level aswell
|This thread has more than 15 replies. Click here to review the whole thread.|