|Topic Review (Newest First)|
|11-23-2012 11:24 PM|
Originally Posted by Darkblade48 View Post
|11-22-2012 04:59 AM|
I've never used perma-seals, mainly because of their cost (~$8 or so to get one).
Whenever I go get my cylinder refilled, I just ask for some nylon washers, and the technician is more than happy to give me a few each time. I'm slowly building up my supply
|11-22-2012 04:57 AM|
|ronaldvalente||Thanks! Looking to get a permaseal as well.|
|11-22-2012 04:51 AM|
Do not worry too much about the amount of CO2 that leaked out into your room.
When you remove the regulator from the CO2 cylinder, each time, you must use a new nylon washer. Screwing the regulator onto the cylinder compresses the nylon washer, forming a tight seal. Compressed/used washers cannot be used again since they will not form a tight seal.
In any case, make sure you use a new nylon washer, tighten the nut by hand, and then take a suitably sized wrench to it and really tighten it.
Following this, I have never had a leak between the CO2 nut and the cylinder (other parts notwithstanding )
|11-22-2012 02:28 AM|
Help - CO2 Leak
I finished the setup of my pressurized CO2 system today. All was working well for about 6 hours... until a fast leak occurred between the tank and regulator. I was lucky I was right there to turn off the tank.
I have it turned off for the night until I can keep a close eye on it during the day.
It is a 5lb tank, the room my tank is in is 5000 cubic feet.
In theory that would be about 16ppm if I did my math right of additional CO2 to the room. Still not fun to hear 800 psi of CO2 leaking into the room.
Is there a better option than a nylon seal?
Is that reliable and I just need to torque down the connection better next time?
Any help is greatly appreciated!