|11-28-2012 04:38 AM|
|RobMc||Thanks for the help guys. I think I'll go with some glass corner braces just to feel safe - but this rim's got to go.|
|11-26-2012 02:55 AM|
|Merth||Looks like a 30gal not a 29|
|11-25-2012 05:39 PM|
I have removed all the rimming on my old 29L. I resealed after, its also on a foam pad. The glass is 3/8 I believe and it bows an 1/8 inch on each side unbraced. It has been up and running for a number of years and had zero probs. I also fill it up to around half inch from the top. I'll post a couple pics tonight.
Sent from my DROID4 using Tapatalk 2
|11-20-2012 05:39 PM|
Definitely add the brace. I removed the rim from a 10gal and didn't add a brace, but that's a much smaller tank. The longer the face of the tank is, the less outward pressure it can handle.
Sent from my Galaxy Nexus using Tapatalk 2
|11-20-2012 04:58 PM|
|Allentan97||brace would deffinately be needed, btw thats not a 29|
|11-20-2012 03:39 PM|
|GMYukonon24s||Nice pieces of wood|
|11-20-2012 03:23 PM|
It is an older tank - holds water just fine, but if derimming (if possible) should I reseal?
It's this tank right here:
|11-20-2012 03:12 PM|
Derimming - 29g - 36x12x16 - 3/8" thick?
DIY experts, I have a question!
Do you think it is safe to remove the top rim only of a 30g tank that's 36" long built from 3/8 inch glass.
The DIY aquarium calculator here http://www.theaquatools.com/building-your-aquarium says that 1/4 inch would be fine with a safety factor of "3.8" - but I'm not sure how this translates to rimless.
In this case would it be best to add a glass brace?
Thanks so much,