|Topic Review (Newest First)|
|11-16-2012 10:17 PM|
Clean when the flow slows just a bit.
My set up is, following the path of the water:
Coarse sponge over the intake (in the tank)
Inside the filter:
Blue and white bonded pad
Chemical media (varies: Soft water tanks have peat moss, hard water tanks have coral sand)
Fine floss (quilt batting)
All media gets rinsed in old tank water and reused.
The quilt batting can get rinsed 3-4 times before it starts to mat together, the blue and white media lasts about twice as long.
Sponges seem to last forever (they don't- I threw one away last year!)
Bio media lasts forever, but I have heard of bleaching a small amount of it to clean out all the pores that cannot come clean with rinsing. The theory is that by rotating, doing no more than 25% of the bio media at any one time there is plenty of bacteria to grow into the cleaned media, and the better water flow improves the conditions so the bacteria grow better. I do not do this. Just slosh the media around in old tank water like all the other media.
|11-16-2012 10:04 PM|
My Eheim 2028 is as follows. Just switched to this media setup so I will check back with my cleaning schedule. Been in for about a month.
|____| <-- Scrubbies and fine filter floss
|____| <-- Scour Pads
|____| <-- Fluval Pre-Filter Media
|11-16-2012 09:17 PM|
|whiptail||I clean the Ehiem canister about every 3 mo. Every thing gets rinsed and reused. Every 6 mo I change the white fine filter material. The carbon pad is just a sales gimick. Throw it out, especially if you are going to have live plants. It will take some of the nutrients out of the water.|
|11-16-2012 09:04 PM|
I've got a Fluval 406 and I clean out my filter every month. Every first weekend of the month, I take out all my media (only have sponges and biomedia) and I give them a good rinse/squeeze in old tank water. So much crap comes out of my sponges, it's insane! I've been debating about doing it twice a month, but I think that's overkill. I have yet to replace any sponges either (filter has been running for almost a year now). I took out the fine filter floss that was in there because it was cutting down too much on my flow.
Here's how I have my filter chambers filled
|____| <-- sponges (top)
|____| <-- biomedia
|____| <-- biomedia
|____| <-- sponges (bottom)
Hoses I do every other month. I make a H2O2/tap water solution (1:4) and run a powerhead on each hose for 30 minutes
|11-16-2012 04:33 PM|
|roadmaster||I clean canister's each month, and hoses about every three month's.|
|11-16-2012 04:25 PM|
3 months for me. I have 2 canister filters (Fluval 306 and SunSun 302) and they are cleaned first and last week of the month.
I only rinse the bio media with tank water as well as the foam pads on my fluval. The SunSun has the blue filter pad (Marineland blue bonded pad) that I toss and replace with a new one. I have Purigen bags that I regenerate and replace into whichever canister is up for maintenance.
|11-16-2012 01:07 AM|
Since all tanks are different, there is a wide range of when the filter will need cleaning. For a start on deciding, you can take a quick look on the Eheims without disconnecting anything. When it is dark, shine a bright light(LED?) on the canister side and you can often see how much grunge is building up. If it looks full, I clean it but I never get a full year on any of my tanks. 3-6 months is normal for me.
I would see no connection between filter cleaning and algae buildup. I might guess that would be due to phosphate or other nutrient or lighting problems.
|11-16-2012 01:00 AM|
Originally Posted by U2Kent View Post
I would say after a year, you would require a thorough cleaning.
As mentioned already, you just really need to rinse off your biomedia and coarse filter pads. Again as mentioned, only the filter floss (the white pad) needs to be thrown out and replaced.
It is also cheaper to just buy cotton batting (make sure it does not have any flame retardants) and cut to size rather than buying the brand name filter floss.
|11-16-2012 12:46 AM|
I personally go in every 6 months and change out the sponge pads depending on how nasty it looks after it's cleaned out in tank water, Bio-media just gets rinsed in tank water to get off any large deposits, the Filter floss is usually at the top of the filter and that gets replaced at least once a month (or more depending on bio-load).
Filter floss is similar to quilt batting, Pillow stuffing. It kinda looks like a polyester cotton ball, it can be found at most LFS and just about every craft store I've ever been in.
I don't use carbon in my canister at all I use Chemi-Pure since it lasts for 6 months before needing to be replaced. If I need to use carbon for any reason I have a powerhead filter that I use for that purpose.
|11-16-2012 12:39 AM|
Originally Posted by mott View Post
|11-16-2012 12:05 AM|
No need to replace any bio media, only fine floss, as a matter of fact a lot of people back flush their classics to lengthen the time before a thorough cleaning.
Take the can to the sink and turn the input at the bottom downwards to the sink, pull the floss, pour a few gallons of tank water over the bio, replace floss, should get you a few more months of service before a thorough cleaning.
|11-15-2012 11:50 PM|
|Fdsh5||I have a Fluval 405. I have biorings in 3 baskets and pillow stuffing in the last one. That's all you need|
|11-15-2012 11:48 PM|
Originally Posted by jkan0228 View Post
I'm going to follow this for cleaning:
I'm thinking I'm overdue as it's been a year. going to tear it down soon and clean it out but I think I've gotta order some replacement media first. Rex is recommending replacing half of the ehfi Substrat bio media. Is this standard practice?
|11-15-2012 01:21 AM|
Originally Posted by Crispino Labayen Ramos View Post
Originally Posted by U2Kent View Post
|11-15-2012 01:18 AM|
Originally Posted by Tanman19az View Post
|This thread has more than 15 replies. Click here to review the whole thread.|