|Topic Review (Newest First)|
|10-31-2014 07:42 PM|
|jimmyjam||i second that!|
|09-16-2014 12:38 PM|
Sorry to revive this old thread but frankly, this and your pressurized CO2 thread, are the two absolute best primers out there.
On topic, I was very interested in your explanation about how the WPG has fallen apart (not to mention LED being a completely different bag). Simple question: How does the single 13watt CP over my Fluval Flora (basically a 12" cube) rate? I'm guessing "low light". Would a second one take me up to "Medium", or would that be getting towards what would be considered "high"?
|09-15-2014 01:06 AM|
|lauraleellbp||Hey Anthony, your pic links are broken!|
|09-18-2013 01:51 PM|
Originally Posted by danaj11 View Post
I use 2 2L bottles for 20 gallons.... just do maths but that is a lot of bottles to renew every 2 weeks..
|08-26-2013 04:09 PM|
if i wanted to start a 55g tank how many diy co2 you think for it 3? Since I have only 1 diy on my 10g
|06-28-2013 06:19 PM|
Fantastic article! I'm going to be referencing it myself often and referring other to it as well! I have a few clarifications and a couple ideas I'd like to get opinions on.
First - I'm setting up a 50g heavy, i'd like to nail down the CO2 before adding fish, but dont know how much CO2 the fauna(phishies & inverts) will increase the concentration in the tank. Ie the tank begins without fauna at 20-25ppm CO2 with room for an additional 5-10ppm CO2 when the fish and such are added so that I dont exceed the recommended 30ppm.
Second - Is the drop checker a one time check that you need to refill for each reading or is it progressive?
Ideally i think it would be cool to have 2 drop checks, one with a 4dKh solution to make sure im under and one with a 3dKh solution to make sure i have enough CO2. Any thoughts on that?
|06-03-2013 03:11 PM|
Hi, I have this plants in a riparium newly planted:
Do you think I need a co2 diffuzer in it (it's only 11 gal)? Any fertilizer outside/inside? (there will be fish in one month)
|05-07-2013 01:00 AM|
oK...So I just did this DIY and after a couple of hours of hunting around this was the best I could do:
Now....I didn't have the proper tool to cut a larger hole out of the top of this salt shaker I bought...so left it thinking that the holes that were already in it may work......well after a couple hours the solution is still dark blue.
Mind you, I did follow all the direction and scaled up the mixture to 30mL of distilled water/baking soda, and 54 drops of the solution from the API pH test kit (9 drops x 5)....
Do you think that this is because I didn't cut the hole in the salt shaker head to make a bigger surface area? Or do you think it may be because of the tubing I connected to the paint tip applicator up to the 'air' in the shaker?? Maybe a combination of both?
|02-23-2013 01:37 PM|
Whilst some say higher levels CO2 do not reduce dissolved oxygen in the water (it sometimes can, depending on other factors) even moderate increases can have some fish gasping at the water surface. If it doesn't affect the dissolved O2 then what's going on?
To diffuse the CO2 out of their blood across their gill surfaces, fish require a concentration differential between the water and the blood. As the differential diminishes due to increased CO2, the gas exchange slows and stops. The fish can't excrete the CO2 and they die. This is sometimes exacerbated by aquarists 'turning off' the air stone so as to reduce CO2 loss at the surface. This the results in lowering the dissolved O2. Then the lights go out and the plants start respiration. They stop eating CO2, start using oxygen and the balance tips and in the morning you find some dead fish and it's a mystery.
|02-19-2013 05:33 PM|
Originally Posted by jwm5 View Post
The only thing I can't find is a small enough bottle for this the only one I can find is an old spice jar that's glass and about 3" long/ deep would that still be accurate if filled just under the top of the glue cap there will be a lot of space in there?
|02-15-2013 03:28 AM|
Live out in the Estates? I just moved from Naples... lol
My advice is just try and see... learn to observe your plants, they'll start discoloring if they need iron.
|02-15-2013 03:16 AM|
although i do now have a question, i have well water down in south florida, and my water is very high in iron. i have Flourite substrate and also the liquid Flourish (from another tank, have not used it with the substrate tank). would my high iron in the water decrease my need for the liquid fertilizer?
or am i overthinking it? lol
|02-15-2013 03:11 AM|
|NurseKorin||That was some easily understandable information that really halped me figure out the CO2 my plants need =) thanks a bunch|
|01-18-2013 08:40 PM|
Plant fertilizers are available as liquid or substrate fertilizers. Both should only contain the micro nutrients. Liquid fertilizers have to be dosed more frequently; substrate fertilizers will last longer. Since there are no obvious differences in efficiency, it is up to the aquarists' preference which to use.
Next to the micro nutrients, fertilizers contain chelates. The chelate is an organic molecule which binds metal ions thus protecting them from early precipitation. The preferred type is abbreviated DTPA because of its stability up to a pH level of 7.5
Unfortunately some fertilizers contain the chelate EDTA, which is much cheaper. However chelate EDTA is only stable at a pH up to 6.0 and therefore mostly useless in aquariums.
What do you think?
|01-17-2013 05:32 PM|
|binbin9||Nice thread. I'm following this one.|
|This thread has more than 15 replies. Click here to review the whole thread.|