Eevbay 110998388539 any good? Can't find info on it.
As is it's not Co2 ready.
Components needed to make it above complete for our purpose. If you can find them cheaper or in SS then go for it, your call. This is just to steer you in the right direction if you want a high qual reg.
= CGA 320 Carbon Dioxide Nipple Washer Brass, used along with the nut below.
= CGA320 Regulator Inlet Nuts. Goes over stem above and what allows the regulator to be attached to the Co2 tank.
= Brass Plug 1/4" NPT Male, Hex Head Solid Brass. Used to replace the lower left open fitting and seal the reg.
= Swagelok Pipe Hex Nipple,1/4 in. Used to replace the left knob assembly -> screws into Solenoid below.
= Solenoid Brass Valve 1/4 NPT Air Water Gas 115V-120V w/ Hose Barb. The barb fitting connects to the other end of the solenoid from there use a tube to connect it to the needle valve below.
@ fabco-air dot com= $23 from manufacturer website. Not the best needle valve, but it doesn't suck either. It will get the job done
= 10-32 1/8" tubing brass barb. Connects to the Fabco needle valve so that you can attach tube that feeds your diffuser or whatever.