Quote:
Originally Posted by Hoppy
Yes, but closer to:
With all of the dimensions the same: .25 inch wide groove, .25 inch deep, set .25 inches from the end. Then setting the table saw to cut them is easiest, and it is at least as strong as any other configuration. |
That does seem very easy, now if I only had a table saw...hmmm. I do have a 3/8" router bit that I bet I could do something like this. I will have to experiment. I am hoping, like you said, that I can set it once and then just space it with some type of makeshift jig to make the cuts for multiple parts. And with the dado set at .25" you can also run the groove the length for the bottom, correct?
Thanks again Hoppy, I really really appreciate it.