The Planted Tank Forum - View Single Post - Guide: Arduino based LED controller for Current Satellite LED+
View Single Post
post #39 of (permalink) Old 07-25-2013, 01:05 AM Thread Starter
Planted Tank Enthusiast
Indychus's Avatar
PTrader: (8/100%)
Join Date: Feb 2013
Location: Irmo, SC
Posts: 652
The remote still works, until another command is sent from the Arduino, at which point it defaults to the programming again. It would be easy to put the Arduino inline between the receiver and light fixture if you don't mind cutting the factory wires to the receiver, allowing you to hide the controller and still have the receiver exposed. The Arduino outputs 5V on this channel, so you'd just have to make sure 5V is what the fixture needs. I'm pretty sure most PWM signals are 5V, so it should be good.

The Fraternity of Dirt
Check out my open-source Arduino-Powered Light Controller Guide for Current LED+ and other IR switchable lights.
Indychus is offline  
For the best viewing experience please update your browser to Google Chrome