Thread: PVC CO2 Manifold
View Single Post
Old 11-06-2006, 03:32 AM   #7 (permalink)
DiabloCanine
zogsichzurückteufelhunden
 
DiabloCanine's Avatar
 
PTrader: (80/100%)
Join Date: Aug 2005
Location: Between yoink & RMC in the U.S. of A
Posts: 1,628
Default
The PVC was drilled and tapped, only ran tap half in to get a tighter seal with the needle valve. Threads are coated with loctite at almost all my CO2 connections. Haven't had any leaks since I started using loctite.....DC

Quote:
Originally Posted by Wasserpest View Post
I'd be concerned with leaks... How exactly did you connect the bubble counters to the pvc pipe?
__________________
Swap n Shop Power Pimpmaster Commandant

DISCLAIMER: the above posted comments are just some guys opinion, they are not nor claim to be fact.
Projects:*Sliding Glass Top*CO2 Reactor*Portable UV Sterilizer*PVC CO2 Manifold*Water Filtration/Storage/Distribution*37G Drilled w/PVC Heater & Reactor Manifold*55G Drilled w/Inline Heater & Reactor*110G Sumped w/Eheims & Magnums*46G Drilled w/PVC Heater & Reactor Manifold *Fish Room*
DiabloCanine is offline   Reply With Quote