The Planted Tank Forum - View Single Post - Lighting an Aquarium with PAR instead of Watts
View Single Post
post #5 of (permalink) Old 07-21-2012, 05:23 PM Thread Starter
Planted Tank Guru
Hoppy's Avatar
Join Date: Dec 2005
Location: Sacramento, CA
Posts: 19,675
When light shines into an aquarium the air-water interface slightly focuses the light. Beams off center are refracted towards the center. This is why the PAR around the center of the tank goes up when you add water. Near the glass at the front, back, and ends, there is considerable reflection of light back into the tank from the glass-air interface, which increases the PAR near the glass. But, if the glass is less than perfectly clean on either side of the glass the amount reflected back into the water is decreased. As I recall I did those PAR measurements in a 10 gallon tank, which I didn't take pains to clean thoroughly. The glass must have been non-uniformly dirty. This was a few years ago, so my memory of that isn't perfect.

I don't have either a 30 inch long tank, nor a 24 inch long light to do PAR tests with. Most of the data I have comes from others who either post it or PM it to me. Someone with the right tank and light, and access to a PAR meter, needs to do that testing. One thing I do know is that if you raise the light far enough above the top of the tank a short light can light up a tank well enough for our purposes. In fact one good way to light a tank is to use a short, but very bright light (4 bulb T5HO, for example) suspended a foot or more above the tank. That greatly reduces the difference in PAR between the water surface and substrate level, and gives relatively uniform light over the substrate.

Hoppy is offline  
For the best viewing experience please update your browser to Google Chrome