The Planted Tank Forum - View Single Post - Wy Renegade's 30gal Paludarium
View Single Post
post #18 of (permalink) Old 02-17-2012, 02:57 PM Thread Starter
Wy Renegade
Planted Tank Obsessed
Wy Renegade's Avatar
Join Date: Nov 2011
Location: Wyoming
Posts: 384
Originally Posted by toksyn View Post
I like where you are going with this and I have a few comments.

I would be a bit hesitant to use the Ponderosa pine chunk ... I don't know how long you've had it, whether its been kiln dried, sealed, etc. but pines and cedars tend to exhude oils toxic to animals (plants too). Short of sealing the wood, I think it's safer just to steer clear of these woods.

As for substrate, have you considered ABG (Atlanta Botanical Gardens) mix? Many amphibian breeders, especially those who specialize in dart frogs, use ABG as the substrate of choice. It contains a lot of "chunky" material to prevent the substrate from getting compacted and promoting anaerobic decomposition. For a high humidity environment, I would suggest a layer of hydroton or leca, a sheet of weed block or fine mesh, then layered with ABG, and finished with a smattering of dead leaves. I would strongly discourage premixed potting soils unless you get some without added fertilizer, and definitely avoid perlite as it will stick to amphibians and causes impaction if ingested.
Thanks so much for taking the time to look, but especially for the comments!Appreciate the feedback on the Ponderosa - based on your input I believe I'll pass on that, since it has been treated in none of those ways. Really appreciate the comments on the substrate. I'm off to check on those items now. Everything I read said not to add any thing with added chemicals, so I was assuming that meant all those slow release fertilizers, but wasn't sure. Also very good to know on the perlite as well.Thanks again.

Last edited by Wy Renegade; 04-16-2012 at 06:38 PM.
Wy Renegade is offline  
For the best viewing experience please update your browser to Google Chrome