The Planted Tank Forum - View Single Post - My 75 gallon derimming project.
View Single Post
post #35 of (permalink) Old 03-17-2011, 11:58 PM Thread Starter
Wannabe Guru
nalu86's Avatar
Join Date: Oct 2010
Location: Kennesaw, Ga
Posts: 1,105
Originally Posted by Hoppy View Post
With that little bowing out, I think I would make 4 glass triangles about 2 inches on the side going against the end glass, and about 6 inches on the side going to the front/back glass. Then glue them in and I don't think there is any chance of problems. For safety I would knock off about 1/4 inch of the sharp point on the triangles, and break all of the corners so they aren't sharp. The corner braces should virtually eliminate the bowing.

I'm assuming that the tank won't come apart in a week of testing. To "proof" test it, push out on the front/back glasses with about a 1 pound push. That should increase the load on the glass by about 50%.
I think i will go with the triangles and the other piece.

I pulled on the glass really hard and no problem at all.
I'm almost 100% sure it will hold.

Last edited by nalu86; 03-18-2011 at 02:38 AM.
nalu86 is offline  
For the best viewing experience please update your browser to Google Chrome